Measurement tool should ignore overlapping paths

point 4.10.3 Measurement Guides in the handbook says, that overlapping paths will be ignored by the measurement tool. But this does not work for me. Is there a switch somewhere?

No answer? Is it switchable somewhere or overwritten by any plug-in secretely?

I did I made it like you asked some time ago and people complained :wink: so I changed it back.

What would be an example of a case in which it’d be useful to not ignore them?

1 Like

In this case for example.

Master 1

Master 2

Hi guys!
Perhaps could be possible this solution. Adding a new tag with the sum of all parts.