Printing Issue

Design
1

Forgive my ignorance, but I’m having a bit of an issue with the letter “P” in one of my fonts. It prints fine for me, but other users have reported that it fills in the center of the p (Believe this is called the counter or bowl in typespeak)

Can someone suggest what nodes need to be deleted, added, etc? I’d be eternally grateful!

http://1796df2131ff86579fd4-4e7f3b3c5b2fb48c7c35fae4f66fd3ab.r51.cf1.rackcdn.com/Scre en%20Shot%202014-10-03%20at%2011.23.58%20PM.png

2

Try:

  1. Layer > tidy up paths
  2. Layer > add extremes
  3. Layer > correct path directions

Perhaps read this:
http://www.glyphsapp.com/tutorials/drawing-good-paths

3

You need to add a extrem point at the rightmost part of the inner path. Use the pen tool, hold down the shift key and click on the path near the right side of the path.

4

Ah! Thank you guys so much. Your support and software is outstanding. :slight_smile: