Selecting Corner Components


#1

In some setups it’s hard to select corner components because the label is obscuring other nodes.
I have to remember to select from left to right or zoom really close to overcome this.
Maybe there’s a better way to place the labels?

18


#2

All at once? Press cmd-A multiple times.

A specific one? Select an ‘easy’ one and press tab repeatedly until the intended corner is selected. Shift-tab tabs the opposite way.


#3

What about a few? Selecting from left to right is annoying don’t you think?


#4

Select all and deselect?

You also have the skills to write a component selection tool that ignores paths and anchors.