At some point I found the TTFA hinting got screwed up and I’d have glitchy outlines when printed. I finally pinpointed some complex glyphs that when set to not export fixed the issue. Is there some way of keeping them in the set but circumventing the hinting on them specifically?
- Do not use these options: Adjust subglyphs and Hint Composites
- Set your Hinting Limit as low as possible (consider something in the range of 60–80 ppm)
- Double check your
Ohornoutline, consider a left/right control instruction on the extrema (of the O part).
Thank you! Will give this a whirl 